OPERATION
System Selector Switch
The System Selector switch on the front of the thermostat 44110 determines
the operating mode of the thermostat. You may select COOL, OFF, HEAT.
NOTE: Anytime you install or remove the thermostat from the wall plate,
slide the System Selector to the OFF position to prevent the possibility
of a rapid system On-Off.
Fan Switch
The Fan switch should normally be located in the AUTO position. The Fan
will be turned
on along with normal operation of your system. In a normal gas or oil
furnace, the Fan will
be turned on by your furnace after its warm-up delay. For electric heat,
air conditioning,
and heat pump operation, the Fan will turn on with the system.
To run the Fan on continuously, slide the Fan switch to the
ON position.
Temporary Manual Override
To temporarily change the current set temperature without affecting your
program on your hunter programmable thermostat model 44110:
• Press and hold for about 1 second to enter Manual Override mode.
When display flashes, you can release the key.
• Press again to change to your desired Set Temperature. Hold the
key for 2 seconds to fast-advance the Set Temperature.
• Press to return to normal mode, or wait 15 seconds for it to return
automatically.
• The current program number will flash to signify the Temporary
Override.
• At the next program change time, the Temporary Override is cancelled,
and the next program temperature becomes the setpoint temperature.
To end the Temporary Manual Override:
• Press, then press again. This will return the set temperature
to the current program set temperature.
Permanent Override
To hold your Manual Override for vacation or just an extended period of
time:
• Press to make the current program temperature the HOLD temperature.
HOLD will be displayed on the LCD, and the Program number will disappear.
• Follow the Temporary Manual Override instructions above to change
the Permanent Manual Override temperature.
• You can confirm the held set temperature by pressing for less
than 1 second.
To end the Permanent Manual Override:
• Press again. The thermostat will return to the current program,
and the HOLD display will be canceled.
Low Battery Warning
Your 44110 hunter thermostat has a two-stage low battery warning system.
When the batteries are first detected to be weak, the first stage low
battery warning is indicated by battery symbol flashing on the LCD display.
At your earliest convenience, you need to replace the batteries with 2
new AA alkaline batteries.
When the batteries become too weak for normal operation, the thermostat
enters the second stage low battery warning which shuts down the thermostat.
In this condition, “BATT” flashes alone on the display, and
the thermostat will turn your system Off. Your system will remain shut-off
until the batteries are replaced.
Note: The programmable thermostat will still keep the current time and
your programs in memory until new batteries are installed. After confirming
that new batteries have been inserted, the thermostat will return to normal
operation.
HUNTER LIMITED WARRANTY
The Hunter Fan Company warrants your Hunter thermostat to be free from
defects in material and workmanship for a period of one year from the
date of sale to the original user or consumer purchaser.
If your Hunter thermostat malfunctions or fails within the warranty period
because of a defect in material or workmanship, Hunter will replace it.
This warranty is voided if your Hunter thermostat 44110 is not purchased
and installed in the U.S.A. This warranty excludes and does not cover
defects, malfunctions, or failures of your Hunter thermostat which were
caused by repairs by persons not authorized by Hunter, mishandling, improper
installation, modifications or damage to the Hunter thermostat while in
your possession, or unreasonable use, including failure to provide reasonable
and necessary maintenance.
|
